ACOUSTIC GEOMETRY CORNERSORBER NOW SHIPPING

Acoustic Bass Management (ABM) product line provides accurate reproduction of sound in any space

bb99be37 6c8b 4e6b a1a4 fbf485621806

Acoustic Geometry is excited to announce the newest product in its Acoustic Bass Management (ABM) line, the CornerSorber, is now shipping. This corner-placement bass absorber utilizes a Mass-Loaded Vinyl (MLV) absorption membrane in a cutting-edge design that mitigates low-frequency room modes for the most accurate sound reproduction in a room.

Created by John Calder and Mark Stender of Acoustic Geometry, the CornerSorber is the only laboratory-proven bass absorber design that allows maximum pressure-zone room-mode reduction due to close-corner placement. The uniquely-shaped bass absorber is beveled on two sides and the top, allowing a pair of CornerSorbers to be set up three inches from, and parallel with, each corner wall, either vertically or horizontally, for the most efficient and effective reduction of low-frequency room-mode pressure waves.

a2e926ac 4740 4251 942c 84d9e3293ec3

"In developing the CornerSorber, our design goal was to give customers an affordable, easy-to-use solution that would realistically reduce destructive low-frequency room modes," says Calder. "We also wanted to avoid claiming product attributes that were not accurately tested in large enough facilities or with real-use positioning. We tested the CornerSorbers at NWAA Labs. Their test chamber is the largest in the U.S., and accurately measures absorption down to 40Hz per ASTM C423. We also tested the products where they'll be located in audio rooms, which is deep into ninety-degree corners. The test results show that this close-corner setup creates a very efficient and effective low-frequency absorber. Needless to say, we're very happy with the results."

www.acousticgeometry.com